Front axle tether kit sized for 2-3/8 Inch axle tubes. Check the axle tube diameter with calipers before ordering, as the three MPD sizes are close enough that guessing from appearance is unreliable and the clamp must match the tube to hold properly. Individual tethers, clamps and hardware are also available separately once the system is installed.
Kit includes two billet clamps, two 31 Inch tethers and all hardware.
Approved for use by Knoxville Raceway and the WoO (World of Outlaws), this front axle tether system adds a measure of safety to open wheel racing in the event of front axle breakage. Supplied with 2-3/8 Inch billet clamps that install easily to the front axle, with tethers then connected to the front motor mount tube. Kit includes (2) billet clamps, (2) tethers, and required hardware.
Tether, clamp, and hardware kits are also available separately for replacement purposes, or for spare front axles.
Details:
- Location / Position: Axle
- Color: Black
- Finish: Natural
- Length: 31 Inch
- Intended Axle Tube Diameter: 2-3/8 Inch
- Tether Quantity: 2
- Clamps Included: Yes
- Clamp Quantity: 2
- Clamp Material: Aluminum
- Clamp Color: Black
- Clamp Finish: Anodized
- Hardware Included: Yes
- Logo: MPD Logo
Specifications
| Part Number | MPD10501 |
|---|---|
| Cat 3 | Chassis and Suspension Safety Restraints |
| Country of Origin | USA |
| Shipping Weight | 1.45 lb |
| Shipping Dimensions (L x W x H) | 8.05 x 7.65 x 2.6 in |
⚠ CALIFORNIA WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Product Information Sheet
